Xerox Telecopier 7033 Service Manual page 227

1.3 Repair / Adjustment
REP 1.3.1 Auxiliary Tray Assembly Separation
Removal
1. Remove both output trays, the handset (if installed), and both
paper trays.
2. Remove two screws from auxiliary tray rear cover, and remove
cover.
3. Remove right side cover (REP 4.1.2) and rear cover (REP 4.1.7).
4. Remove screws from lower paper guide, and remove guide.
5. If installed, remove screws securing ground wires to electrical box.
6. If installed, remove the hard disk drive assembly.
a. Remove the rear access cover an disconnect P/J271 and P/J272
from the hard disk interface PWB.
b. Remove two mounting screws and slide hard disk assembly
partially out of auxiliary tray assembly.
c. Disconnect P/J275 from the hard disk power supply.
7. Carefully place terminal on its left side.
8. Separate the auxiliary tray assembly from the terminal.
a. Slide paper input roller drive belt off of pulley.
b. Disconnect P/J194 from bottom of electrical box.
c. Remove 3 front securing screws, and loosen 3 rear securing
screws, then carefully slide the auxiliary tray assembly away
from terminal.
1.4, 1.4.1
Replacement
1. Perform removal procedure in reverse order.
6/92
www.printcopy.info
8a-3 Telecopier 7032 / 7033 Service Manual