Xerox Telecopier 7033 Service Manual page 81

4.4 Upper Printer Assembly
Parts List on PL 5.6a and 5.6B
Perform the indicated steps to remove a desired part.
Stop shaft
Primary pulley
Frame assembly
Secondary pulley
Pressure roller, pulley, and gear
Pressure roller idler shaft
Release latches
Removal
1. Remove printer cover assembly. (PL 5.1A)
a. Disconnect power cord.
b. Lower the right side cover.
c. Open printer cover.
d. Loosen four printer cover screws.
e. Partially close the upper printer, and remove the cover.
left end must be lifted up first, and then slide the cover away
from upper printer hinge shaft.
2. Remove left side cover. (PL 5.1A)
a. Remove document and copy output trays.
b. Remove three (3) screws securing left side cover.
c. Slide out left side cover.
3. Remove control panel. (PL 5.1A)
a. Disconnect power cord.
b. Remove control panel bracket rear cover.
recessed in center of cover.
c. Disconnect J190 on rear of control panel.
d. Loosen three screws securing control panel to bracket (Figure
1).
e. Lift off the control panel.
Telecopier 7032 / 7033 Service Manual
1 2 3 4 6
1 2 3 4 9
1 2 3 4 5
1 2 3 4 6
1 12
1 13
1 14
One screw is
www.printcopy.info
7 8
6 7 8 9 10
7 9 11
Loosen screws
The
Figure 1. Control panel removal
4. Remove rear cover. (PL 5.1A)
a. Disconnect power cord, telephone line cord, and handset cord
from rear of terminal, and remove handset from cradle.
b. Remove PWB access cover.
If installed, disconnect RS-232 and/or encryption interface
cable(s).
Remove one screw securing panel.
8/91
4-23
Machine
Front
J 190
7033-226
4.4 Upper Printer Assembly