Xerox Telecopier 7033 Service Manual page 65

4. Remove control panel. (PL5.1A)
a. Disconnect power cord.
b. Remove control panel bracket rear cover. (One recessed screw
in center of cover.)
c. Disconnect J190 on rear of control panel.
d. Loosen three screws securing the control panel to the bracket
(Figure 2).
e. Lift off the control panel.
Loosen screws
Figure 2. Control panel removal
Telecopier 7032 / 7033 Service Manual
5. Remove rear cover. (PL5.1A)
a. Disconnect power cord, telephone line cord, and handset cord
b. Remove PWB access cover.
c. Remove left rear cover screw (Figure 3).
Machine
Front
J190
7033-226
d. Lower the right side cover, and remove right rear cover screw.
e. Remove one screw (on rear of terminal) securing rear cover.
f.
8/91
www.printcopy.info
4-7
from rear of terminal, and remove handset from cradle.
If installed, disconnect RS-232 and/or encryption interface
cable(s).
Remove one screw securing panel.
Remove screw
Remove screw
Figure 3. Rear cover removal
While lifting rear cover up, pull bottom sides away from
terminal.
4.2 ADF and Upper Scanner
Remove screw
7033-227