1.3.2 Hard Disk Power Supply
Removal
1.
Disconnect the power cord.
2.
Remove the rear access cover.
3.
Remove the hard disk assembly.
a. Remove the rear access cover an disconnect P/J271 and P/J272
from the hard disk interface PWB.
b. Remove two mounting screws and slide hard disk assembly
partially out of auxiliary tray assembly.
c. Disconnect P/J275 from the hard disk power supply.
4.
Loosen the screws securing the cover, and lift off the cover.
5.
Disconnect P/J274 from the hard disk power supply.
6.
Turn the hard disk drive assembly over and set it on a flat surface.
7.
Remove the two screws securing the power supply to the bottom
plate.
Replacement
1.
Perform removal procedure in reverse order.
Telecopier 7032 / 7033 Service Manual
1.3.3 Hard Disk Interface PWB
Removal
1.
Remove the rear access cover.
a. Disconnect telephone line and handset cords.
b. If installed, disconnect the RS-232 or encryption interface
cable.
c. Remove screw securing access cover, then remove plastic and
metal cover.
NOTE:
The metal cover may be secured by a screw on an
existing option PWB. Remove the screw.
2.
Disconnect P/J271 and P/J272 from the interface PWB.
3.
Slide the hard disk interface PWB out of the option mother PWB.
Replacement
1.
Perform removal procedure in reverse order.
6/92
www.printcopy.info
8b-5
1.3.2, 1.3.3