Xerox Telecopier 7033 Service Manual page 61

4.1 Covers
Parts List on PL 5.1A and 5.10
Perform the indicated steps to remove a desired part.
Printer Cover Assembly
Right Side Cover
Left Side Cover
Lower Front Cover
Upper Front Cover
Control Panel
Rear Cover
EMI Shield
Removal
1. Remove printer cover assembly. (PL 5.1A)
a. Disconnect power cord.
b. Lower the right side cover.
c. Open printer top cover.
d. Loosen four top cover screws.
e. Partially close the upper printer, and remove the cover.
left end must be lifted up first, and then slide the cover away
from upper printer hinge shaft.
2. Remove right side cover. (PL 5.1A)
a. Disconnect power cord.
b. Lower the right side cover.
c. At the terminal frame, remove the screw securing the nylon
restraint.
d. Single tray unit. Slide door away from frame.
e. Double tray unit. Slide auxiliary paper tray out approximately
4 to 6 inches.
f. Double tray unit. Slide front end of door away from frame,
then pull out back end of door from frame.
Telecopier 7032 / 7033 Service Manual
1
2
3
3 4
3 4 5
6
3 6 7
3 6 7 8
www.printcopy.info
3. Remove left side cover. (PL 5.1A)
a. Disconnect power cord.
b. Remove document and copy output trays.
output tray retaining screw one-quarter turn, then pull tray
straight out.)
The c. Remove three (3) screws securing left side cover.
d. Slide out left side cover.
8/91
4-3
(Turn document
4.1 Covers