Xerox Telecopier 7033 Service Manual page 284

1.5.2 LAN Fax Server Option (Token Ring Version)
Note: Before installing the Fax Server PWB enter the Service Mode and
obtain a copy of the Options Report. From the Report and table
below confirm that the required Firmware levels to support the
option are installed into the terminal.
Note: The LAN Fax Server option can not co-exist with any other
option already installed in the terminal.
option remove all other existing options.
1. This option requires a terminal with firmware level 6.01 (Tag 15) or
higher.
2. Obtain an Options Report. Verify the Rom Program Version to the
following:
ROM NAME
Ram/Rom PWB MR0
MR1
MR2
MR3
FT0
G3 PWB G3M
3. Install the auxiliary tray if not already installed. If the auxiliary tray
option contains a firmware upgrade kit, install only the firmware
listed in step 2.
Note: The auxiliary tray is part of the base RX 7033 terminal and is not
considered as an option.
4. Perform a Diagnostic Self Test to verify correct machine operation.
Note: During the installation of the hardware the network supervisor
can be installing the software onto the network following the
procedures in the Supervisors Handbook.
5. Remove the Fax Server PWB, option mother PWB, access cover, EMI
shield, manuals, hardware and software and disks from the shipping
carton.
6. Disconnect the power cord from the terminal.
7. Disconnect the telephone line and handset cord.
1.5.2
Before installing this
VERSION
6.01/4400
6.01/BB00
6.01/6F00
6.01/B800
6.01/7900
6.01/0E00
6/92
www.printcopy.info
8h-20
8. Remove the screw securing the Access cover, then remove the plastic
and metal covers.
9. If not already installed, install the Option Mother PWB. Set the PWB
on the guide and slide it to the left to connect P1 to J230 on the
main PWB. Secure the upper right corner of the PWB to the
electrical box using the hardware provided with the option.
10. The Token Ring version PWB is factory set for 16 Mbps. If a speed of
4 Mbps is required proceed to step 11. If not, proceed to step 12.
11. Locate the jumper W1 on the Fax Server and move the jumper to the
4 Mbps position (Refer to figure 6).
Figure 6 Data Rate Selection
4 Mbps Speed
16 Mbps
12. Install the Fax Server PWB into the terminal.
13. Remove the required plastic knock-out (s) on the access cover for
external harness connections to the Fax Server PWB.
14. Install the metal EMI shield and the plastic access cover and secure
with hardware.
Note: The RX Token Ring PWB also requires a ground plate. Install the
ground plate between the Token Ring PWB and the Telephone
Line Filter PWB with the grounding screws. Install plastic access
cover.
4 Mbps Speed
Jumper W1
3 2 1
Jumper pins 1 & 2 (as illustrated above)
Jumper Pins 2 & 3
Telecopier 7032 / 7033 Service Manual