Xerox Telecopier 7033 Service Manual page 79

27. Remove lower paper chute assembly. (PL 5.5)
a. Remove paper guide spring from inside front of terminal
(Figure 20).
Tension
Spring
Figure 20. Lower paper chute assembly removal
b. Slide chute assembly to the left in order to clear the paper
output roller.
c. Lift chute up and out of terminal.
Avoid contact with the printer jam sensor actuator during
replacement of chute, ensuring lower paper chute assembly is
positioned properly in bearings.
4.3 Lower Scanner Assembly
View rotated 90°
Front
frame
Lower
paper chute
assembly
Lower paper chute assembly
CAUTION
28. Remove scan motor. (PL 5.4B)
a. Remove plastic wire guide.
b. Disconnect the scan motor's in-line connector P/J120, and
release harness from plastic wire guide.
c. Remove the paper tray.
d. Loosen two motor mounting screws on rear frame (Figure 21).
Motor
mounting
screw
7033-247
e. Release drive belt from pulley.
Metal edges are sharp in the paper tray compartment.
f. Reach into paper tray compartment and hold motor while
removing the mounting screws with your fingers.
g. Carefully slide motor out through paper tray compartment.
8/91
www.printcopy.info
4-21
Rear
Frame
Scan
motor
Figure 21. Scan motor removal
WARNING
Telecopier 7032 / 7033 Service Manual
Machine
Front
Drive
belt
Motor
mounting
screw
7033-248