Xerox Telecopier 7033 Service Manual page 94

24. Remove paper input roller #1 shaft joint. (PL 5.8)
a. Loosen set screw securing shaft joint (Figure 14).
b. Remove shaft joint.
Loosen
set screw
Shaft
joint
Figure 14. Shaft joint removal
25. Remove paper input roller #1. (PL 5.8)
a. Remove front and rear bearings.
b. Remove paper input roller #1.
26. Remove paper input roller #2. (PL 5.8)
a. Remove E-rings and bearings from front and rear of shaft.
b. Remove paper input roller #2.
27. Remove thermal head sensor pulley, lever, sensor actuator.
(PL 5.7B)
a. Remove thermal head sensor drive belt.
Telecopier 7032 / 7033 Service Manual
Machine
Front
7033-263
8/91
www.printcopy.info
4-36
b. Remove donor film cartridge.
c. Remove screw securing sensor actuator (Figure 15).
Sensor
actuator
Pulley
Lever
Thermal
head lever
assembly
E-ring
Figure 15. Thermal head sensor pulley, lever, and actuator removal
d. Remove sensor actuator.
e. Remove E-ring securing thermal head lever assembly to lever.
f. Remove lever.
g. Remove pulley.
28. Remove pulley support. (PL 5.7B)
a. Remove two screws securing pulley support.
b. Remove pulley support.
7033-264
4.5 Lower Printer Assembly