Bin Level Sensors; Safety Limitation; Unload Button; Selecting Output Destination And Staple Mode - Xerox DocuPrint N24 User Manual

Bin Level Sensors

Safety Limitation

Unload Button

Selecting Output
Destination and
Staple Mode
Finisher ensors can detect the following bin conditions:
s
Empty
50%
Full
When a bin is full and the stack height does not allow
additional sets to be sent to it, the destination of additional
sets directed to the full bin is determined by the Output
Timeout system parameter in the printer's System Menu. See
Table 2 on page 17.
When Finisher Bin 3 is selected, the bins are raised to the
highest position. In the interest of safety, they will only
remain in this position for (1) one minute following the last
page delivered to bin 3. After one minute, the bins are
lowered to align bin 2 with the output paper path.
The Unload Button temporarily interrupts printing and places
the finisher in the home position to allow the operator to
remove output. It also signals the controller to sense stack
height in the bins and resume printing after the stack has
been removed. Figure 1 on page 6 illustrates the position of
the unload button.
These parameters can be set via the System Menu at the UI
[see "Finisher Menu Options" (page 19)] or by PCL and PJL
commands [see "Finisher Specific Commands" (page 32)].
9