Xerox Telecopier 7033 Service Manual page 69

Removal
1. Remove left side cover. (PL 5.1A)
a. Disconnect power cord.
b. Remove document and copy output trays.
c. Remove three (3) screws securing left side cover.
d. Slide out left side cover.
2. Remove lower front cover. (PL 5.1A)
a. Remove the screw from the right end of the cover (Figure 1).
Loosen screw
Figure 1. Lower front cover removal
b. Loosen the screw on the left end of the cover.
c. Slide cover to the right, and remove.
3. Remove upper front cover. (PL 5.1A)
a. Loosen two screws securing front top cover.
b. Lift up cover.
4.3 Lower Scanner Assembly
4. Remove control panel. (PL 5.1A)
a. Disconnect power cord.
b. Remove control panel bracket rear cover. (One recessed screw
c. Disconnect J190 on rear of control panel.
d. Loosen three screws securing the control panel to the bracket
e. Lift off the control panel.
Remove
screw
Lower
front
cover
7033-225
8/91
www.printcopy.info
4-11
in center of cover.)
(Figure 2).
Loosen screws
Figure 2. Control panel removal
Telecopier 7032 / 7033 Service Manual
Machine
Front
J190
7033-226