Xerox Telecopier 7033 Service Manual page 93

20. Remove clutch assembly. (PL 5.9)
a. Remove donor film cartridge.
b. Remove screws securing paper feed solenoid (Figure 12).
Belt
Remove
E-ring
Figure 12. Clutch assembly removal
c. Move solenoid assembly far enough to allow clutch assembly
to slide off of shaft.
d. Remove E-ring from rear of feed shaft assembly.
e. Remove belt from clutch assembly.
f. Remove clutch assembly.
21. Remove feed shaft assembly. (PL 5.9)
a. Remove E-ring and bearing from front of shaft.
b. Remove second E-ring and bearing from rear of shaft.
c. Slide shaft to rear to clear front frame and remove shaft from
terminal.
4.5 Lower Printer Assembly
Clutch
Paper feed
solenoid
Remove
screw
7033-261
www.printcopy.info
22. Remove belts from paper input rollers #1 and #2. (PL 5.8)
23. Remove roller shaft pulleys. (PL 5.8)
a. Remove belts from printer motor assembly pulley (Figure 13).
Pulley
E-ring
Figure 13. Pulley removal
b. Remove front E-ring from shaft.
c. Remove roller shaft pulley.
8/91
4-35
Roller shaft
pulley
7033-262
Telecopier 7032 / 7033 Service Manual