Chapter 5 System Setup In The Non-Sterile Environment; Overview; Assembling The Handpiece; Powering Up The System - Integra CUSA Clarity System Service And Maintenance Manual

Chapter 5 - System Setup in the Non-Sterile Environment

5.1 Overview

This section describes the steps for setting up the CUSA® Clarity System in the non-sterile environment.

5.2 Assembling the Handpiece

Assemble the handpiece in a non-sterile environment - see System Setup in the Sterile Field (Section 4.2).
WARNING
To ensure sterility, assemble handpiece and tip in a sterile environment.

5.3 Powering Up the System

Press the System Power On/Off button on the console (Classification and Console Symbols). The console sounds a startup tone.
Note
The purpose of the startup tone verifies that the audio alarms are functioning correctly. If this tone does not sound during the startup process,
contact Integra for service.

5.4 Attaching the Footswitch

Align the red dot on the footswitch cable connector with the red dot on the footswitch port on the rear of the console and plug in the footswitch cable.
CUSA® Clarity System Service and Maintenance Manual Page 31 of 117 0645403-2-EN