Preparing To Use The System; Operating The System - Integra 90520 Operation And Service Manual

Integra
®
LED Surgical Headlight System
Preparing to Use the System- With Battery Option
1. Clip the Battery Holster in a comfortable location.
4
2. Insert and fully seat the Battery into the Battery Holster. For proper
battery orientation, align the battery so that the 5-pin connector in
the holster mates with the 5 slots on the battery. The battery label
will be visible through the opening in the outside surface of the
holster, as shown in Figure 4.
3. Approximate battery continuous run time is dependent on switch
setting, level of charge and calibration state of battery. On a fully
charged battery, approximate run times are:
• High Switch setting is approximately 2 hours plus low battery
notification cycle
• Medium Switch setting is approximately 2 1/2 hours plus low battery
notification cycle
• Low Switch setting is approximately 3 hours plus low battery
notification cycle
With AC/DC Power Option
1. Connect the AC/DC Power Supply to the supplied AC Mains power cord. Plug the AC Mains power cord into any
standard 100 VAC to 240 VAC 47-63 Hz outlet.
2. Connect the output cord of the AC/DC Power Supply to the Extension DC Power Cord. Align the connectors and push
firmly until they are firmly seated. The connector pins are not keyed and will accept either orientation.
9
4