Restore To Factory Default Settings - ICP DAS USA PDS-220F Series User Manual

Programmable Serial-to-Fiber Device Server

4.5.3 Restore to Factory Default Settings

Use the following procedure to reset all parameters to their original factory default settings:
Step 1: Click the "Login" tab at the PDS-220Fx Misc Setup Page to proceed to the Login Page.
Step 2: Enter the password in the "PASSWORD:" field (use the default password "admin") and click
the "LOGIN" button to proceed to the settings page. If you want to change default password,
please refer to Section 4.5.2 "Change
Step 3: Check the "Restore to Factory Default Settings" option and click the "UPDATE" button to
update the setting.
Step 4: Click the "Logout" to complete the operation, and then power-on reboot the PDS-220Fx.
Note:
User can restore PDS-220Fx password to default value "admin" by using "config=RESET" console command
(refer to Chapter 7 "Console/Telnet Commands
setting. It requires rebooting the PDS220Fx for loading new configuration (includes default password).
Password".



List"). This command sets most configurations of PDS-220Fx to factory
PDS-220Fx Series User Manual

Version 1.3, Oct. 2018 - 55 -