Appendix A: Linking To A Development Pc - ICP DAS USA PDS-220F Series User Manual

Programmable Serial-to-Fiber Device Server

Appendix A: Linking to a Development PC

Step 1: Switch off the Power to the PDS-220Fx module.
Step 2: Connect the COM1 (RS-232) connector on PDS-220Fx to COM Port on host PC using the CA-
Note: CA-0910N is a 3-wire Null-modem cable (optional).
0910N cable.
Step 3: Set the "SW1" to the "Init" position.
Step 4: Supply +24 V
DC
Refer to below illustration for how to perform the above procedure.
Host PC
Power Supply
(+12 ~ +48 V ) power to the PDS-220Fx.
DC
Front Panel
CA-0910N Cable
Top Panel
GND
Vs+
PDS-220Fx Series User Manual
COM1
RS-232
COM2
RS-485/422
Version 1.3, Oct. 2018 - 95 -