Hardware Information; Specifications - ICP DAS USA PDS-220F Series User Manual

Programmable Serial-to-Fiber Device Server

2. Hardware Information

This chapter provides a detailed description of the front panel, the hardware specifications, the pin
assignments, the wiring notes and the dimensions for the PDS-220Fx Series.
2.1

Specifications

Models
CPU
CPU
SRAM
Flash
EEPROM
Peripheral
Communication Interface
COM1
COM2
Fiber Port
Fiber Cables
Wavelength
Min. TX Output
Mode Max. TX Output
Max. RX Sensitivity
Min. RX Overload
Budget
Distance
COM Port (16C550 or Compatible UART)
Data Bit
Parity
Stop Bit
Baud Rate
LED Indicators
Link/Act
System
Power
Power Input
Power Consumption
Protection
Mechanical
Dimensions (W x L x H)
Installation
Environment
Operating Temperature
Storage Temperature
Humidity
PDS-220Fx
80186, 80 MHz or compatible
512 KB
512 KB; Erase unit is one sector (64 KB); 100,000 erase/write cycles
16 KB; Data retention: 40 years; 1,000,000 erase/write cycles
Watchdog Timer, Init Pin
Male DB-9, 5-wire RS-232 (RxD, TxD, CTS, RTS, GND); Note: +/- 4 kV ESD Protection
Removable Terminal Block
2-wire RS-485 (D+, D-, GND) with Self-Tuner ASIC or
4-wire RS-422 (TxD+, TxD-, RxD+, RxD-, GND)
Note: +/- 4 kV ESD Protection
100 Base-FX, 100 Base-FX,
ST connector SC connector
Multi-mode: 50/125, 62.5/125 or 100/140 μm
1300 or 1310 nm
-20 dBm
-14 dBm
-32 dBm
-8 dBm
12 dBm
2 km, (62.5/125 μm recommended) for full duplex
7, 8
None, Even, Odd, Mark, Space
1, 2
115200 bps max.
Green
Red
+12 VDC ~ +48 VDC (non-regulated)
0.14 A @ 24 VDC
Power Reverse Polarity Protection, EMS Protection (Frame GND)
31 mm x 121 mm x 157 mm
DIN-Rail mounting
-25 °C ~ +75 °C
-30 °C ~ +85 °C
10 ~ 90% RH, non-condensing
PDS-220Fx Series User Manual
PDS-220FC PDS-220FCS
Single-mode: 8.3/125, 8.7/125, 9/125 or 10/125 μm
-15 dBm
-8 dBm
-34 dBm
-5 dBm
19 dBm
30 km, (9/125 μm
recommended)
for full duplex
31 mm x 123 mm x 157 mm
Version 1.3, Oct. 2018
PDS-220FCS-60
-5 dBm
-0 dBm
-35 dBm
30 dBm
60 km, (9/125 μm
recommended)
for full duplex
- 12 -