ICP DAS USA PDS-220F Series User Manual page 35

Programmable Serial-to-Fiber Device Server
Item
Network WDT timeout
(System Timeout) (ms)
Master IP
Reset System
SET TCP/IP
Description
If the PDS-220Fx does not receive any data from any of the
clients within the period of the "Network WDT timeout", the
module will reboot itself.
This setting is the same as "SystemTimeout" setting (unit: ms)
on Console/Telnet command, and is the same as "/STxxx" in
command line parameter (unit: seconds).
When user uses "config=RESET" Console/Telnet command to
clear the EEPROM,
(SystemTimeout, /ST) setting will also be cleared to 0.
Users have to configure this setting again by "SystemTimeout"
Console/Telnet command.
0 = Disabled, Min. setting value = 30000
If the Master IP is set, only the client using Master IP can change
the COM Port configuration. It is to prevent the COM Port
configuration changed by other clients.
If the "Reset System" option is checked, the PDS-220Fx will reboot itself after the
saving operation is complete, otherwise the original settings will still be valid until the
next power-on.
Click this button to save the revised settings to the PDS-220Fx.
PDS-220Fx Series User Manual
the "Network WDT
Version 1.3, Oct. 2018
Default
0
(Disabled)
timeout"
empty
- 35 -