Dhcp; Udp - ICP DAS USA PDS-220F Series User Manual

Programmable Serial-to-Fiber Device Server

7.3.17 DHCP

This command is used to set the DHCP client to either enabled or disabled.
DHCP function will get a dynamic IP address setting for PDS-220Fx automatically. Thus it's
recommended to disable DHCP function and use a static IP address setting. This prevents you to
configure virtual COM mappings again and again.
Effect: Immediate
Command Arguments
DHCP = 0
DHCP = 1
The figure illustrates is an
Figure 7-3-17:
example of a DHCP configuration.

7.3.18 UDP

This command is used to configure the UDP Search function.
UDP is used to set the action mode for when a PDS-220Fx receives a UDP search command.
Effect: Immediate
Command Arguments
UDP
= 0
UDP
= 1
UDP = 2
:
The figure illustrates is an
Figure 7-3-18
example of a UDP configuration.
Description
Disables the DHCP client.
Enables the DHCP client.
Description
Rejects UDP search commands.
The PDS-220Fx will not reply to the UDP search command, and can not be searched
again.
Replies to UDP search commands.
The PDS-220Fx will reply to the UDP search command, and can be searched.
Replies to UDP search commands till a client is connected.
PDS-220Fx Series User Manual Version 1.3, Oct. 2018 - 89 -