Connection For Side-By-Side Installation Of Cabinet Units - Siemens SINAMICS S120 Manual

Mechanical installation
3.3 Installation
3.3.6

Connection for side-by-side installation of cabinet units

Description
An accessories kit is provided with each cabinet or transport unit for the connection of
cabinet units in a side-by-side installation. The table below shows the content of this
accessories kit for connecting the cabinet units.
Table 3- 2 Content of the accessories kit for connecting the cabinet units
Quantity Material
1 x Sealing strip
3 x Cabinet connectors, outer
including the mounting
material
3 x Cabinet connectors, inner
including the mounting
material
Preparatory steps
● Allow unimpeded access to the profiles in the cabinet interior (if necessary, remove the
Assembling
1. Glue the sealing strip to the cabinet frames of the cabinets to be connected.
2. Push the cabinets together, they must come completely together both at the front and
3. Attach the cabinet connectors to the outside and inside corresponding to the subsequent
4. If necessary, reattach the protective covers and doors. The ground connections must also
58
Fig.
side panels, doors, and protective covers).
rear sides. The distance between the cabinets must be approximately 3 mm.
drawing.
be attached to the doors.
Notes
The sealing strip must be glued to the cabinets before
connecting them.
The cabinet connector is attached from the outside and
screwed tight from the outside.
Tightening torque: 9 Nm
The cabinet connector is fixed using 4 screws.
Tightening torque: 5 Nm
Cabinet Modules
Manual, 03/2013, A5E03263538A