3. Fit the hood to the top of the enclosure at the positions specified (fixing points for the
4. Attach the original M12
5. Attach the M6 screws and washers at the front side (sequence: screw, spring-lock
6. If the hood is very wide, insert additional screws
Figure 8-62
Cabinet Modules
Manual, 03/2013, A5E03263538A
crane transport assemblies).
element, small washer, large washer)
rear).
View with opened cabinet door
8.46 M23/M43/M54, degree of protection IP23/IP43/IP54
①
roof screws from above at the rear side.
②
from below.
③
in the center of the hood (front and
Options
533