Siemens SINAMICS S120 Manual page 117

Cable routing to the customer terminal block -X55
1. Feed the cable for the customer terminal block into the cabinet from the bottom left.
2. Remove approx. 3 cm of the cable insulation at the level of the shield plate in the lower
3. To secure the cable in accordance with EMC requirements, snap the clip onto the shield
4. Use cable ties to secure the cable at suitable points.
5. Guide the cable further up into the cabinet and, when it reaches customer terminal block -
6. Use cable ties to secure the cable at suitable points.
7. Connect the cables to the customer terminal block -X55.
Cabinet Modules
Manual, 03/2013, A5E03263538A
Frame size:
FB GB
part of the cabinet and attach the cable there.
plate.
X55, guide it to the left or right to -X55. When doing so, route the cable in a similar
manner to the standard cables that have already been installed in the cabinet.
GD
Electrical installation
4.6 Connections
115