Installation Via Network Connection - Siemens SINUMERIK 810D Commissioning Manual

Installing software and network operation
3.1 Installing software and software update
3.1.5

Installation via network connection

Overview
This function transfers the HMI software to be installed to D:\INSTALL on the PCU. The
actual installation is carried out by Windows on the next booting, provided the software
includes an exe file, e.g., "setup.exe".
Note
Prior to the installation process, ensure that hard-disk partition D has sufficient free memory
space.
If you are using a different language version of the Windows system, the terms used in the
following setting operations may be different. The sequence of operations as specified
below, however, is always the same.
Operator action
While the PCU is ramping up (after switching the controller off and then on again)
1. Select the "Service menu" [hidden menu entry] in the Boot Manager.
2. Press key <1>: Install/update SINUMERIK system
3. Enter one of the passwords for authorization levels 0 - 2.
Your Choice [1, 2, 3, 9]?
4. Press key <3>.
3-8
The main menu is displayed:
The system prompts you to enter a password:
The following menu is displayed:
PLEASE SELECT MEDIUM:
1 Install from Floppy Disk
2 Install via Serial/Parallel Line
3 Install from Network Drive
9 Return to Main Menu
An input screen is displayed in which you can specify settings for the network if
necessary:
Commissioning Manual, 10/2006, 6FC5397-0DP10-0BA0
PCU Basesoftware (IM6)