Other Connections; Cable Routing; General Information - Siemens SINAMICS S120 Manual

4.6.11

Other connections

Depending on the range of options installed, further connections may have to be made.
For more information about the interfaces of available options, refer to the relevant sections
in this manual.
4.6.12

Cable routing

4.6.12.1

General information

Hazardous electrical voltage
The work described in this section is carried out in cabinets that are operated in industrial
high-voltage installations. During operation, this cabinet contains rotating and live parts. For
this reason, there is a risk of severe injury or significant material damage if the required
covers are removed without authorization, if it is used or operated incorrectly, or if it has not
been properly maintained.
You must read the safety information and application notes.
Basic rules for cable routing
The Cabinet Modules are delivered pre-wired.
The following basic rules must always be observed for all Cabinet Modules should any
additional cabling and wiring or connection work be necessary.
● Observe EMC guidelines.
● Use existing routing for cable assemblies.
● Always use the shield plates provided (do not bypass them).
● Use existing cable propping bars as required.
● Attach the cable ties at suitable points on metal frames and cabinet frame profiles.
● Use a cabinet upright to route cables into adjacent cabinets.
● Refit any covers removed during cable routing before completing the work and
Cabinet Modules
Manual, 03/2013, A5E03263538A
DANGER
commissioning!
Electrical installation
4.6 Connections
107