Siemens SINAMICS S120 Manual page 131

Cable routing for DRIVE-CLiQ connections and signal cables to the Control Unit
1. Feed the DRIVE-CLiQ/signal cable into the cabinet from the bottom left.
2. Use cable ties to secure the cable at suitable points.
3. Feed the cable up through the cabinet and, when it reaches the Control Unit, guide it up
4. Use cable ties to secure the cable at suitable points.
5. Connect DRIVE-CLiQ/signal cable to the Control Unit.
Cabinet Modules
Manual, 03/2013, A5E03263538A
Frame size:
FX+GX HX+JX
and to the right towards the Control Unit. When doing so, route the cable in a similar
manner to the standard cables that have already been installed in the cabinet.
Electrical installation
4.6 Connections
129