Restoring Factory Defaults - SKF On-line System WVT User Manual

range after this time, the IrDA interface is turned off after 20 seconds to conserve
power.

Restoring Factory Defaults

On the left side of the main board is the DEFAULTS push button. This is accessible
through the hole in the transparent barrier that is required for hazardous area
installation. The DEFAULTS push button is is used to restore the unit to its factory
default settings.
To reset the unit to its factory defaults:
• Press the push button on the outside of the unit to illuminate the display.
• Hold down the DEFAULTS push button for five seconds. The countdown status is
shown on the display.
After the five second countdown, a message states: Device Defaults Being Reset.
SKF Multilog On-line System WVT
User Manual
Figure 2 – 6.
Five Second Countdown in Progress.
Figure 2 – 7.
Device Defaults Being Reset Message.
 The SKF Multilog WVT will lose network connection after being
returned to factory defaults. It will have to be reprovisioned to
rejoin.
Hardware Overview
Internal Overview
2 - 7