SKF On-line System WVT User Manual page 22

System Overview
Safety Messages
L'antenne utilisée pour ce transmetteur doit être installé pour fournir une distance de
séparation d'au moins 20 cm de toutes les personnes et ne doit pas être co-localisés ou
fonctionner en conjonction avec une autre antenne ou transmetteur.
Personnel Safety
Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing, and
gloves away from moving parts.
Do not overreach. Keep proper footing and balance at all times to enable better control
of the device during unexpected situations.
Use safety equipment. Always wear eye protection. Non-skid safety shoes, hard hat, or
hearing protection must be used for appropriate conditions.
Do not repair or adjust energized equipment alone, under any circumstances. Someone
capable of providing first aid must always be present for your safety.
To work on or near high voltage, you should be familiar with approved industrial first
aid methods.
Always obtain first aid or medical attention immediately after an injury. Never neglect
an injury, no matter how slight it seems.
Keep minimum safe distance from the antenna. This equipment complies with FCC RF
radiation exposure limits set forth for an uncontrolled environment. The antenna used
for this transmitter must be installed to provide a distance of at least 20 cm (8 in.) from
all persons and must not be co-located or operating in conjunction with any other
antenna or transmitter.
Device Safety
Do not operate the equipment without the antenna connected.
Device service must be performed only by qualified SKF repair personnel.
Use only accessories recommended or provided by SKF USA Inc. or the manufacturer.
Energized Equipment
Never work on energized equipment unless authorized by a responsible authority.
Energized electrical equipment is dangerous. Electrical shock from energized equipment
can cause death. If you must perform authorized emergency work on energized
equipment, be sure that you comply strictly with approved safety regulations.
No Submersion/Immersion
This equipment is IP66 rated, is dust-tight and resistant to powerful jets of water. Do
not immerse in any liquid. If the instrument is subjected to these conditions, adverse
operation may result, and there is a risk of serious injury or damage should fire occur.
Avoid Damage and Injury
To avoid costly damage to the instrument or injury from a falling instrument, place the
instrument on a solid stable surface when not in use and do not place any heavy objects
on it.
1 - 2 SKF Multilog On-line System WVT
User Manual