Software Requirements - SKF On-line System WVT User Manual

The data acquisition section of the SKF Multilog WVT acquires samples according to the
downloaded configurations at a user defined interval. Each SKF Multilog WVT
automatically publishes trend measurements through the network. The trace
measurements are, however, required to be directly uploaded by the software from the
SKF Multilog WVT according to the user defined schedule.
Identification in the Wireless Network
Each SKF Multilog WVT device on the network is distinguished by a unique 64-bit
EUI64 identifier. This number is permanently programmed into the SKF Multilog WVT
unit at the factory and cannot be changed, similar to a MAC address. Devices are
authenticated onto the network by provisioning, which provides each SKF Multilog WVT
device with a key to allow it to communicate with the WDM. Provisioning is discussed in
detail later in this user manual.

Software Requirements

SKF provides the following software and related documentation supporting the SKF
Multilog WVT:
• SKF @ptitude Analyst software (host computer resident)
• SKF Multilog On-line System WVT Product CD containing:
–
–
–
–
SKF Multilog On-line System WVT
User Manual
 CMWA 7910-FCC/IC has the radio power level of 11 dBm, as
specified by the Federal Communications Commission (FCC) and
Industry Canada (IC).
 CMWA 7910-ETSI has the radio power level of 4 dBm, as
specified by the European Telecommunications Standards
Institute (ETSI).
SKF Multilog On-line System WVT User Manual (this document)
Wireless Device Manager (WDM) User Interface User Manual
DataController software
CSA Certificate of Compliance
System Overview
Software Requirements
1 - 7