SKF On-line System WVT User Manual page 145

8. Apply extra adhesive, as needed, to perimeter of mounting pad and form radius to
prevent fluids from migrating under pad. Immediately remove any adhesive from
pad top surface.
9. Hold mounting pad in place 1 to 2 minutes until adhesive begins to set. After 1
hour setting time, carefully unthread screw from pad. Adhesive full cure time is 24
hours.
10. Apply thread locking compound to sensor mounting screw.
11. Thread sensor screw onto mounting pad, observing maximum torque (24 lbf-in.,
2.7 N-m).
12. Apply silicone dielectric grease to sensor connector socket. Fill connector half full
with dielectric grease.
13. Align the connector with the accelerometer socket key. Push connector firmly onto
accelerometer and screw on connector for the IP67 rating.
14. Install first cable restraint within 8 in. (20 cm) of sensor; install additional cable
restraints every 18 to 24 in. (45 to 60 cm).
15. Trim cable to length as needed.
SKF Multilog On-line System WVT
User Manual
 Remove connector by pulling straight out, slightly wiggling the
connector.
Figure A - 5.
Mounting Pad Installation, Surface.
Mounting Pad and Sensor Installation Instructions
Installing the Sensors
A - 5