Advertisement

SKF TKST 11
Instructions for use

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TKST 11 and is the answer not in the manual?

Questions and answers

Summary of Contents for SKF TKST 11

  • Page 1 SKF TKST 11 Instructions for use...
  • Page 2: Table Of Contents

    Table of contents Safety precautions .......................... 3 EU Declaration of Conformity ......................4 UK Declaration of Conformity ......................4 1. Instructions for use ........................4 2. Technical data ........................... 6 3. Getting started: ........................7 4. General usage ........................... 7 5.
  • Page 3: Safety Precautions

    Do not expose the equipment to high humidity equipment operation. In case of any uncertainties as or direct contact with water. regards the use of the equipment contact SKF. • All repair work should be performed by an SKF repair shop.
  • Page 4: Eu Declaration Of Conformity

    TKST 11 These operating instructions are an integral part of the device. They must be stored in an easily We, SKF MPT, Meidoornkade 14, 3992 AE Houten, accessible location and passed on to subsequent The Netherlands herewith declare under our sole users.
  • Page 5 Fig. 1 – Stethoscope SKF TKST 11 General aspect of the device SKF logo Battery status Volume level: digit and graphics Direct access Direct access button function button function Fig. 2 – Wireframe...
  • Page 6: Technical Data

    1. Direct access button left: volume down 2. Direct access button right: volume up 3. Direct access button center: mute 2. Technical data Designation TKST 11 Frequency range 30 Hz - 15kHz Operating temperature -10 to +45 °C (14 - 113 °F)
  • Page 7: Getting Started

    For this reason, do not The output jack plug on the side is there in order to direct it at any moving part of a machinery. plug a recording device (not sold by SKF). Please follow the steps below when setting up the device: •...
  • Page 8: Troubleshooting

    Do not store the stroboscope in very hot or cold environments. 6. Spare parts and accessories Designation TKST 11 TKST-PROBES 2 probes set TKST-HEADS Headset TKST 11-CB Toolcase with inlay for TKST 11 TDTC 1/B General toolcase without inlay, size B...
  • Page 12 | mapro.skf.com | skf.com/mount ® SKF is a registered trademark of the SKF Group. © SKF Group 2022 The contents of this publication are the copyright of the publisher and may not be reproduced (even extracts) unless prior written permission is granted. Every care has been taken to ensure the accuracy of the information contained in this publication but no liability can be accepted for any loss or damage whether direct, indirect or consequential arising out of the use of the information contained herein.

Table of Contents