Checking The Chain, Rear Sprocket, Engine Sprocket, And Chain Guide - Husqvarna FC 450 Rockstar Edition 2022 Owner's Manual

11.41

Checking the chain, rear sprocket, engine sprocket, and chain guide

SERVICE WORK ON THE CHASSIS 11
Main work
–
1
Loosen nut
–
2
Loosen nuts
–
Adjust the chain tension by turning adjusting screws
and right.
Guideline
Chain tension
Turn adjusting screws
markings on the left and right chain adjusters are in the
same position relative to reference marks
wheel is then correctly aligned.
–
Tighten nuts
–
Make sure that chain adjusters
adjusting screws
–
1
Tighten nut
Guideline
Nut, rear wheel spin-
dle
F03681-10
Info
The wide adjustment range of the chain adjusters
(32 mm (1.26 in)) enables different secondary ratios
with the same chain length.
Chain adjusters
Finishing work
–
Remove the motorcycle from the lift stand. (
Preparatory work
–
Raise the motorcycle with a lift stand. (
Main work
–
Shift the transmission to the neutral position.
–
Check the chain, rear sprocket and engine sprocket for wear.
» If the chain, rear sprocket or engine sprocket is worn:
–
Change the drivetrain kit.
400227-01
.
.
58 ... 61 mm (2.28 ... 2.4 in)
3
on the left and right so that the
2
.
4
are fitted correctly on
3
.
.
M25x1.5
4
can be turned by 180°.
Info
The engine sprocket, rear sprocket and chain
should always be replaced together.
3
left
A
. The rear
80 Nm (59 lbf ft)
p. 48)
p. 48)
75