Installation Of Controlcommand; Prior To Setup; Installation - RAID Xanadu User Manual

8.3

Installation of ControlCommand

If you have not purchased ControlCommand, this task is unnecessary.
8.3.1

Prior to Setup

Before beginning ControlCommand installation, be sure of the following.
By installing ControlCommand, the functions of the host information collection command
(iSMcc_hostinfo) become available.
Refer to the "ControlCommand on Linux Installation Guide" for details about OS
environments in which the host information collection command (iSMcc_hostinfo) can be
used.
8.3.2

Installation

Install ControlCommand by using the Linux rpm command and following the procedure below.
Refer to the "ControlCommand on Linux Installation Guide" for details. You will find the manual
on ControlCommand on Linux CD.
By installing ControlCommand, the functions below become available.
ReplicationControl
ReplicationControl/DisasterRecovery
SnapControl
ProtectControl
PowerControl
Storage Manager volume list command (iSMvollist)
If any of the software below has already been installed, uninstall all of it before you
install ControlCommand.
If ReplicationControl/DisasterRecovery has been installed, you must uninstall
ReplicationControl/DisasterRecovery before you uninstall
ReplicationControl
ReplicationControl/DisasterRecovery
SnapControl
Storage Manager volume list command
ControlCommandSet or ControlCommand
* Cannot be used on D1 series or D3 series units
- -
67