Led Checks - RAID Xanadu User Manual

16.2

LED Checks

In cases in which state monitoring is not done by iSM, states can be checked at LEDs on devices.
When an abnormality is detected, identification of the location of the abnormality and arrangement
for recovery can be done more rapidly if this is conveyed by the states of LEDs.
Disk array unit (front face)
(1) POWER LED (green)
(2) SERVICE LED (orange)
(3) ACTIVE/FAULT
(orange / green)
Disk array unit (rear face)
PS0 (1) POWER GOOD LED (green)
(2) POWER FAULT LED (orange)
(3) FAN FAULT LED (orange)
PS1 (1) POWER GOOD LED (green)
(2) POWER FAULT LED (orange)
(3) FAN FAULT LED (orange)
CONT0 (4) HPE GOOD LED (orange)
(5) Battery FAULT (orange)
(6) BACKUP LED (orange)
(7) FAULT LED (orange)
(8) READY LED (green)
(9) SAS connector FAUTL LED (FLT) (orange)
CONT1 (4) HPE GOOD LED (orange)
(5) Battery FAULT (orange)
(6) BACKUP LED (orange)
(7) FAULT LED (orange)
(8) READY LED (green)
(9) SAS connector FAUTL LED (FLT) (orange)
Extended BBU (rear face)
Extend (1) CHARGE LED (green)
-ed
(2) BBU FAULT LED (orange)
BBU0
(3) AC switch (orange)
Extend (1) CHARGE LED (green)
-ed
(2) BBU FAULT LED (orange)
BBU1
(3) AC switch (orange)
ON / Blinking / OFF
ON / Blinking / ON for 5 sec. and OFF for 7 sec. / OFF
Alternate blinking orange and green / Only orange ON
Alternate blinking orange and green / Only orange ON
Alternate blinking orange and green / Only orange ON
- -
143
ON / OFF
ON / OFF
ON / OFF
ON / OFF
ON / OFF
ON / OFF
ON / OFF
ON / Blinking / OFF
ON / Blinking / OFF
ON / Blinking / Blinking slowly / OFF
ON / Blinking / OFF
ON / OFF Location (
ON / OFF
ON / Blinking / OFF
ON / Blinking / OFF
ON / Blinking / Blinking slowly / OFF
ON / Blinking / OFF
ON / OFF Location (
ON / Blinking / OFF
ON / Blinking / OFF
ON (-) / OFF (O)
ON / Blinking / OFF
ON / Blinking / OFF
ON (-) / OFF (O)
Location ( )
Location ( )
Location ( )
)
)