RAID Xanadu User Manual page 49

(4) Draw the inner rail to the rear support of the rack and insert the two projections.
Rail front
Relative positions of
projections
Projection (round hole)
Projection (square hole)
Projection (round hole)
Projection (square hole)
(5) Affix the inner rail by inserting M5
screws in the cable clamps in two
center screw holes in the rear
support of the rack.
Make the cable clamp installation
direction as shown in the figure to
the right.
(6) Also install rail (R) on the right-hand side of the rack by the same procedure.
Installation of the rack mount kit is complete.
Installation in rear support
(Square-holed rack)
Inner rail projections
Installing cable clamps and affixing inner rail in rear support
- -
26
Installation in rear support
(Round-holed rack)
Inner rail projections
Right side when installed