RAID Xanadu User Manual page 122

(10) Logical disk binding
If [LD binding] was selected in (9) "Logical disk binding specification", next bind the logical
disk and assign it to the host (business server).
Figure 11.1.17 Logical Disk Binding Screen
Here, for a specified host, set one RAID type or PD (physical disk) type, one logical disk
capacity, and one or more logical disks, referring to the following.
RAID Type/PD Type
Select one of the RAID types/PD (physical disk) types displayed in a pull-down.
LD Capacity
Specify the capacity of the logical disk to bind.
The capacity that is displayed by default shows the maximum capacity of a logical disk that
can be bound if Selection host1 and Selection host2 are specified, excluding the 0.2 GB
capacity of each control volume that is bound.
The maximum capacity shown in the pull-down can be bound if a host is not specified.
Number of LDs
Specify the number of logical disks to bind.
Selection host1/Selection host2
Check this to assign a bound logical disk to a specified host (business server). Host
- -
99