RAID Xanadu User Manual page 29

(a) Getting the WWPN (World Wide Port Name) of the host bus adapter (Fibre Channel
controller)
This setup is only for WWN mode (using the WWPN of the host bus adapter to allocate
LUN to the business server) as the AccessControl setup mode. During the setup task, the
WWPN of the host bus adapter installed on the business server is obtained using software.
However, it is recommended that you make note of it and provide for a substitute task
(confirmation of the server expansion slot location at which the host bus adapter is installed
and the WWPN) in case of a host bus adapter fault.
The WWPN that is assigned to the host bus adapter may have to be input manually if the
WWPN of the host bus adapter cannot be obtained by the software.
(b) Installing the host bus adapter
If a host bus adapter has already been installed in the business server, this task is not
necessary.
Install the host bus adapter in the business server according to the host bus adapter and
business server user's manuals.
(c) Installing the host bus adapter driver
If a driver for the host bus adapter that is installed in the business server has already been
installed and set up, this task is not necessary.
Perform the tasks of host bus adapter driver installation and setup according to the manual
that came with the host bus adapter product installed in the server or information provided
on the Web.
(d) Installing PathManager (Windows/Linux)
If PathManager has already been installed and set up for the business server, or if
PathManager is not being installed, this task is not necessary.
To perform this task, installation and setup of the host bus adapter driver must be done
first.
Perform the tasks of PathManager installation and setup according to the "PathManager
User's Manual" that comes with the PathManager product, or the "PathManager Installation
Guide".
- -
6