RAID Xanadu User Manual page 178

(3) Disk Array Network Setting Initialization
It is possible to initialize the disk array unit network settings in order to perform operations
described in Chapter 11 "Initialization of RAID Storage" from the start.
However, only perform this initialization if network setup by the initialization wizard failed.
Change DIP switches by referring to 15.7 "Changing DIP Switches".
Changing the second switch (Bit2) of the DIP switches initializes network settings at startup.
The value of the second switch of the DIP switches when the network was set up is stored. At
startup, if the value of the second switch of the DIP switches and the stored value differ,
network settings are initialized.
It is not necessary to restore the changed value because a mismatch with the value when the
network was set up is detected.
Since changed values are checked, CONT0 and CONT1 settings need not be the
same.
For initialization, change both CONT0 and CONT1.
On a disk array unit for which initialization already was completed, since there is a
risk of previously set contents being changed by mistake when continuing setup in
the initialization wizard, do not initialize network settings by this method. If
initialization already has been completed, perform 16.3.1 (1) "Changing Network
Settings from Storage Manager".
If network settings have already been initialized by mistake due to DIP switches,
perform the following minimum necessary setup using the initialization wizard.
1. Initialization wizard startup
Click [Next].
2. Disk array specification
Select the disk array unit for which to perform setup and click [Next]
3. Disk array connection confirmation
Click [Next].
4. Setting method specification
Select [Individual Setting] and click [Next].
5. Host information collection method specification
Uncheck [Automatic collection] and click [Next].
6. Network setup
Input the correct values and click [Next] and then click [Execute] after
confirming that there were no problems from the confirmation screen.
7. Host connection port setup
When the screen is displayed, click [Cancel] to terminate.
- -
155