Appendix B. Initialize Wizard File - RAID Xanadu User Manual

Appendix B. Initialize Wizard File

Batch initialization of disk arrays can be performed using an initialize wizard file. This file is
created saving the settings on the Initialization Complete screen of the initialization wizard. To
prevent the same IP address and license from being used for other disk arrays, they are
described as "xxx" in the saved file. This file becomes available by editing the IP address and
license.
Be careful not to edit other items.
The format and sample settings of the initialize wizard file are shown below.
(1) File format
The format to perform batch settings from a user-defined file is explained.
(a) The file is an ASCII character format text file (*.txt).
(b) From a "#" (sharp) to the end of a line is treated as a comment.
(c) A section must be enclosed in [ ] and start from the beginning of a line.
(d) A section description action is in effect until the next section description appears.
(e) A sentence within a section in the syntax for settings by section is complete in one line.
(f) The syntax for settings by section is the format below.
- Key=Value
The setting for Key is described by Value.
- KeyValue.Subkey=Value
This specifies a subkey of the value set above it and describes its setting in Value.
Key and Subkey names vary by section.
(g) If a section name begins with "*", it is not used in setting.
(h) Since uppercase and lowercase characters are distinguished, take care in description.
- -
163