RAID Xanadu User Manual page 187

[Format of initialize wizard file]
# Comment line
Initialization wizard ................... (1)
[SVPConf] ................................ (2)
00h.GateWay=x.x.x.x
00h.IP=x.x.x.x
00h.Mask=x.x.x.x
SVPNO=00h
[License] .................................. (3)
License=XXXXXX-XXXXXX-XXXXXX-XXXXXX-XXXXXX
[*DiskArray] .............................. (4)
Serial=Serial-number
(1) Key information
This has the description "Initialization wizard" as key information to show that the
parameters to follow are a setup file.
(2) Section (Network)
This describes the network (IP address, etc.) to set in the disk array.
Explanation of syntax
Section: [SVPConf]
Key: SVPNO
Subkeys: IP, GateWay, Mask
Syntax: SVPNO=xx
xx.IP=aaa.bbb.ccc.ddd
xx.GateWay= aaa.bbb.ccc.ddd
xx.Mask= aaa.bbb.ccc.ddd
SVPNO: Describes the SVP (service processor) number in 2
IP:
GateWay: Describes a gateway in the same format as an IP address.
hexadecimal digits.
"00h": Service processor number on controller 0 side
"01h": Service processor number on controller 1 side
Represents an IP address in "." delimited decimal notation.
- -
164