RAID Xanadu User Manual page 170

Disk array unit rear view
(4) HPE FAULT
(6) BACKUP (7) FAULT
(1) POWER GOOL LED (green)
(2) POWER FAULT LED (orange) Power supply fault (excluding the fan)
(3) FAN FAULT LED (orange)
(4) HPE FAULT LED (orange)
(5) Battery FAULT (orange)
(6) BACKUP LED (orange)
(7) FAULT LED (orange)
(8) READY LED (green)
READY LED FAULT LED
OFF OFF
OFF ON
ON OFF
ON Blinking slowly
Blinking OFF
(9) SAS connector
LINK LED (LNK) (green)
FAULT LED (FLT) (orange)
Location and port numbers
DP1 DP0
(10) HP connector
LINK LED (L) (green)
ACCESS LED (A) (green)
Concurrent blinking both
LINK and ACCESS LEDs
Location and port numbers
HP5 HP4
(1) POWER GOOD
(5) Battery FAULT
(8) READY
ON / Blinking
Normal
Fan fault
HPE fault
Battery backup unit status
ON: Fault
Blinking: To be replaced due to its life
Blinking: Battery backup state
Powered off
Occurrence of fault
Power-on sequence in progress
Waiting for disk enclosure power-on
Normal operation
ON: Link-up, OFF: Link-down
ON: Error detection, OFF: Normal
ON: Link-up, OFF: Link-down
ON, blinking: I/O access
Once in 2 seconds: Offline
Twice in 2 seconds: Waiting setup
HP3 HP2
HP1 HP0
(2) POWER FAULT (3) FAN FAULT
(10) HP Connector
(9) SAS Connector (11) LAN Connector
OFF
AC power is not being supplied
Normal
Normal
Normal
Normal
Normal
State
- -
147
Location
PS1 PS0
CONT1 CONT0