RAID Xanadu User Manual page 174

Condition
The message "[25957] LD
binding would not execute
with selected
parameters(RAID type,PD
type,number,capacity).
Please confirm the
parameters." is displayed
over and over
Unable to change the LD
Set name in the logical
disk binding screen
It is assumed that the capacity and number of logical disks that can
be bound in the specified RAID type/PD type is great.
1. Confirm that physical disks with the same capacity are installed
in each RAID type. If [Spare binding] is selected, one more
physical disk is needed for spare.
RAID1 (basic):
RAID6(4+PQ) (dynamic):
RAID6(8+PQ) (dynamic):
In the case of LD Bind Easy Configuration, confirm that there is
a physical disk with the same capacity, which has not been used
to configure RAID, in the Storage Manager client (Web GUI)
main window.
2. If the number of physical disks is sufficient in (1), it is assumed
that the specified capacity and number of logical disks are too
great.
If [Selection host] is selected, there is that much insufficient
capacity since a control volume of 0.2 GB is created per host.
The maximum capacity shown in the pull-down menu cannot be
bound. The logical disk capacity displayed as default is the
maximum capacity of a logical disk to be bound when a host is
specified.
If multiple logical disks are specified, reduce the logical disk
capacity.
Since the LD Set has already been registered, only addition of logical
disks can be performed.
- -
151
Action
consisting of two physical disks
consisting of six physical disks
consisting of 10 physical disks