RAID Xanadu User Manual page 177

Fry Jan 12 14:32:46 2007 0000004380 Info
Address(Product ID=xxxxx ,Serial Number=xxxxxxxxxxxxxxxx) : SVP number=xxh, IP
Address=x.x.x.x, Subnetmask=x.x.x.x, Gateway=x.x.x.x, status=failed
Figure 16.3.1 Storage Manager Client (Web GUI) Message Display Area
*2: If disk array unit network settings and server connections are correct, contact your sales agent.
*3: If there are multiple NIC in the management server, refer to the manual for each server and OS
for the correspondence between IP addresses and NIC.
*4: Since changes to disk array network settings cannot be made until monitoring can be
performed from the Storage Manager server, it is necessary to temporarily change the
management server IP address, subnet mask, and gateway address to configure the disk array
so that it can be monitored.
*5: Change the IP address to that of the NIC that is physically connected to the disk array.
*6: Since the IP addresses of controller 0 and controller 1 cannot be made the same, another IP
address must be set temporarily when switching IP addresses.
*7: To change multiple IP addresses, view device properties in the main screen of the Storage
Manager client and make changes from the side that is not the control path (1).
*8: Since the Storage Manager server environment settings are not changed if the disk array IP
address is changed to an IP address that cannot be monitored after the change, the Storage
Manager server environment settings must be changed manually after making the change.
iSMconfig
Message Display Area
- -
154
iSM14483:Set IP