(c) Settings for each parameter
The settings for each parameter are shown below. The parameters to check vary with the
specification of [Individual setting] or [Batch setting with initialize wizard file] in (4)
"Setting method specification".
<Network Settings> * Only when the initialize wizard file is used
Disk array network settings are displayed.
- Controller
The target controller is displayed.
- IP Address
The IP address to set is displayed.
- Subnet Mask
The subnet mask to set is displayed.
- Gateway Address
The gateway address to set is displayed.
[Example]
--- IP address setting ---
Controller0
IP Address
Subnet Mask
Gateway Address : 0.0.0.0
<Host connecting port> * Only when the initialize wizard file is used
The settings for the host connection port are displayed.
- Port Number
The target port number is displayed.
- Platform
The platform to set is displayed.
- Data rate
The data rate is displayed.
- Host connection type
The host connection type to set is displayed.
- Switch ID
The Loop Switch ID to set is displayed.
: 192.168.2.176
: 255.255.255.0
-
-
105