YASKAWA E-V Series User Manual page 184

6 Utility Functions (Fn
(2) Operating Procedure
Follow the steps below to perform the manual gain-adjustment of analog monitor output.
Step
1
2
3
4
5
6
7
6-18
)
Display Example Keys
Press the
main menu and select Fn00D.
Press the
The display is switched to the execution display of
Fn00D.
• If the display is not switched and "NO-OP" is dis-
played in the status display, the Write Prohibited
Setting (Fn010 = 0001) is set. Check the setting
and reset.
Press the
ment width.
After the gain adjustment of CH1, adjust the gain
adjustment width of CH2 (motor speed monitor).
Press the
Press the
ment width of CH2 (motor speed monitor).
After having completed the adjustment both for CH1
and CH2, press the
The adjustment results are saved in the SERVO-
PACK. After the saving is completed, "Done" is dis-
played in the status display.
Press the
Mode main menu.
Description
Key to open the Utility Function Mode
Key.
or Key to adjust the gain adjust-
Key. The cursor moves to CH2 side.
or Key to adjust the gain adjust-
Key.
Key to return to the Utility Function