STAND-BY mode
4.2
4.2.1 " SELF TEST " phase
Set the main switch (placed on the back of the ventilator) to "I".
•
Make sure that on the ventilator keyboard
(commands area), the green led (that indicates
the presence of mains power supply) is on.
•
Hold the ON-OFF key for few seconds to start
the ventilator.
4-2
" SELF TEST " phase. Close the patient circuit.
"SELF TEST" phase.
During " SELF TEST " phase, the ventilator software carries out the self-diagnostic
tests and checks a series of devices necessary for safe operation of the ventilator.
For more information on the "SELF TEST" please refer to the chapter 3.4.2.
The ventilator turns on and the
automatic " SELF TEST " phase
begins.
•
Turbine functioning check and
status.
•
The system pull out the O
excess in the device in order
to calibrate the 21% O
concentration in a proper way.
User Manual, DU3111103
in
2
2