Table of Contents
Advertisement
5.3
Troubleshooting
This chapter is an indicative but not exhaustive guide for the user and the technician,
providing indications for eliminating, as quickly as possible, most of the problems that may
have caused malfunctioning or alarm signals.
This chapter describes the possible causes of problems, indicated by alarms that are
activated during normal functioning.
5.3.1 Troubleshooting list
Switch ON failure
Power Failure
Initialization phase
- SELF TEST
Falco 101
If the problem persists, carry out a complete check of the lung ventilator to
identify any irregularities.
If the problem cannot be resolved, contact the Siare Service Centre or a
Centre authorized by Siare.
The lung ventilator does not switch on.
•
Check that it is connected to the main power supply.
•
Check that the main switch is turned to the I position (ON).
•
Check the main fuses.
•
Contact the Siare Service Centre or a Centre authorized by Siare.
There is a power supply fault and the lung ventilator is operating on the
battery.
•
Check that it is connected to the main power supply.
•
Check that the main switch is turned to the I position (ON).
•
Check the correct connections of the plug, the fuses and the
connector, and the condition of the cable (if necessary, restore the
connections and replace the cable if it is damaged).
•
Check that power is present at the relative socket by plugging in
another electrical device. If there is no power, use another socket
or check the overload switch on the electrical panel of the room.
The initialization phase is not completed and the system is blocked.
•
Verify and intervene in function on the error messages and
indications evidenced during the "SELF TEST" phase.
•
Turn off and on the lung ventilator and repeat "SELF TEST" phase.
•
If the problem persists, contact the Siare Service Centre or a
Centre authorized by Siare.
5-13
Advertisement
Table of Contents
