Falco 101
STAND-BY operating mode
•
Operating mode active after the SELF TEST phase or before the
switching off of the device.
•
Operative mode where it is possible to set and modify all the
parameters (SETUP, ALARMS etc.) according to the operative mode
to be used in the ventilation of the patient.
In STAND-BY (SET function) you can select the operating mode and set
and/or edit all ventilator parameters (PRP) that belong to the operating
mode in question.
The PRP can also be adjusted while the ventilator runs, adapting them to
the patient's clinical situation.
•
The " SELF TEST " phase
completed successfully.
At the end of the "SELF TEST"
phase the device goes
automatically in STAND-BY mode.
STAND-BY operating mode.
4-3