WAGO I/O-SYSTEM 750 Manual page 96

96 Example Configuration
Restore to factory settings!
The following steps require that the 750-644 I/O module remain intact, i.e. no
configuration has been attempted. If not the case, click the [Factory Settings]
button in the toolbar to restore the 750-644 I/O module to its factory settings.
Click the [Configuration] button in the toolbar. A dialog appears (see
5.
figure "Data Frame dialog").
6. If necessary, enter a process image size of 48 bytes and a Mailbox size of 12
bytes.
7. Click [Apply] to confirm your entries. Then close the "Data Frame" dialog.
8. To refresh the view of the configuration saved in the 750-644 I/O module
click the [Read] button in the toolbar (see figure "Bluetooth
parameterization area").
9. Assign the role of master to the 750-644 I/O module by selecting "Master"
in the Device Role drop-down menu.
Select the Net Forming menu item in the navigation.
10.
The following section describes how to select the devices required to establish a
connection to the master. Devices that are visible for scan requests can first be
scanned for in a similar way to the slave configuration (see section "Example
Configuration" > ... > "Configuring Slaves via 'Net Forming'" steps 10 to 14) and
then be stored by drag & drop for example, from the scan results in the list of
allowed devices (slots 1 to 13). For security reasons, 750-644 I/O modules are
hidden from scan request in "Real-Time Communication" mode, but can be
entered like other hidden devices or devices out of reach:
11. Enter the listed MAC address of the slave, which is already in "Real-Time
Communication" mode, in the intended field manually.
The following steps assume that you are using slot 1.
12. Give the device a name (UserFriendlyName); e.g. "Slave_01". This makes
the overview easier for you.
Select the MAC ID and select the value "Yes" in the Bind drop-down menu
13.
(see figure "Binding a device").
Click the [Write] button in the toolbar to write the modified configuration
14.
to the 750-644 I/O module.
The master and slave are now assigned to each other. The master is still in
"Configuration" mode.
WAGO-I/O-SYSTEM 750
750-644 Bluetooth
Version 2.0.0, valid from FW/HW Version 03/03
®
RF-Transceiver
®
specific
Manual