Connecting To An Android Smartphone - WAGO I/O-SYSTEM 750 Manual

108 Example Configuration
Pos : 81.5 /Serie 750 (WAGO-I/O-SYST EM)/In Betrieb nehmen/Anwendungsbeis piel e 750-644: Ver bindung Smartphone @ 16\mod_1377089096179_21.doc x @ 129368 @ 2 @ 1
9.3

Connecting to an Android Smartphone

We cannot guarantee this functionality
The instructions steps below have been tested representatively for the following
devices:
• HTC Sensation (Android 4.0.3)
• Sony XPERIA U (Android 4.0.4)
• Samsung Galaxy S3 (Android 4.1.1)
• Samsung Galaxy Note 1 (Android 4.1.2)
WAGO cannot, however, provide any guarantee that a link can be set up with
your smartphone, on account of the large variety and rapid development of
standard versions and configurations.
Proceed as follows to link your Android smartphone to the 750-644 I/O module:
1. Reset the 750-644 I/O module to the factory settings.
Activate the Bluetooth
2.
If you already know the Bluetooth
3. In the Bluetooth
"Discoverable for all devices".
4. Using the 750-644 I/O module, scan for other available Bluetooth
Use an unfiltered search, i.e. a search where you specify 0x00 as the CoD
filter.
5. Identify your smartphone in the list of devices found. If your smartphone is
not in the list, repeat the search as necessary.
Enter the Bluetooth
6.
device. For example, use slot 8, i.e. slot address 0x10. Activate this slot for
the connection ("Bind").
7. Set the cut-off for slot 1 ... 7 to 0 and set the cut-off of the slot specified for
the slot to a number between 2 and 16, e.g. 9.
8. Put the 750-644 I/O module in "Ad-hoc Communication" mode.
9. Launch an app on your smartphone that supports Bluetooth
communication.
10. Use the app to establish a connection to the 750-644 I/O module. If
prompted to enter a PIN, use the PIN configured on the 750-644 I/O module
(default "0").
®
function of your smartphone.
®
MAC ID of your smartphone, jump to step 6.
®
settings for your smartphone, set its discoverability to
®
MAC ID of your smartphone as an allowed ad-hoc
Version 2.0.0, valid from FW/HW Version 03/03
WAGO-I/O-SYSTEM 750
®
750-644 Bluetooth RF-Transceiver
®
SPP
®
devices.
Manual