Table 46: Setting Options In The Data Frame Dialog - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
®
750-644 Bluetooth RF-Transceiver

Table 46: Setting options in the Data Frame dialog

Selection box
Process Image Size
Mailbox Size
Button
[Apply]
[Default]
[Close]
Changing the process image size
Please note that the structure of the process image changes when the process
image size or Mailbox size is changed. Therefore, changes in the configuration of
the superordinate controller may be necessary.
On the PI Mapping page, the slave process data is allocated to the slots in the
master (see figure "Screenshot of the PI Mapping page"). Up to 46 bytes of the
process image are available for this purpose (depending on which process image
size was set in the "Data Frame" dialog). The control/status byte and internal byte
are not taken into consideration here.
Manual
Version 2.0.0, valid from FW/HW Version 03/03
Settings
12 Bytes, 24 Bytes, 48 Bytes
*
6 Bytes, 12 Bytes , 18 Bytes
*
Default setting
Description
Transfers the modified parameters to the non-volatile
memory of the 750-644 I/O module. A software reset is
carried out, so that the changes take effect. The dialog
remains open.
Selects the default setting for this 750-644 I/O module. The
[Apply] button then transfers the parameters to the non-
volatile memory of the 750-644 I/O module.
Closes the parameterization dialog without transferring any
modified parameters to the non-volatile memory of the
750-644 I/O module.
Commissioning
*
83