9.1.2.2.9 Setting "Communication" Mode For Master And Slaves; Table 68: Mailbox Command Setlocaloperationmode - WAGO I/O-SYSTEM 750 Manual

WAGO-I/O-SYSTEM 750
®
750-644 Bluetooth RF-Transceiver

9.1.2.2.9 Setting "Communication" Mode for Master and Slaves

1. Set all slaves in "Communication" mode using Mailbox command
"SetLocalOperationMode" (Opcode 0x4A)
(Opcode 0x03 for the ad-hoc profile)
(see table "Mailbox command SetLocalOperationMode").
2. Follow the same steps for the master.
3. Wait 5 seconds after executing the command.

Table 68: Mailbox command SetLocalOperationMode

Byte
PD/O 0x00 0x00 0x00 0x00 0x00 0x03 0x02
PD/I 0x00 0x00 0x00 0x00 0x00 0x00 0x00
Test exchange of process data as described in section "Example Configuration"
> ... > "Testing Process Data Exchange".
Pos : 81.2 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 2.0.0, valid from FW/HW Version 03/03
10 9 8 7
Example Configuration
6 5 4 Toggle Opcode
blank
0x80 0x4A 0x00 0x20
0x80 0x4A 0x00 0x60
105
C/S